Leaderboard

was more thinking that it´s a more relaiable source with a MOLEX connector that you can buy in a lot of different places, with short delivery lead time. I will order some from Mouser to test with. Looked a the USB-PCB from my crashed phone, if I could reuse that PCB to prepare it for a fast swap. But that PCB is quite bent, so I doubt it will work. //Per

Will give it a try with the last nightly OTA Would prefer not to set everything up again 🙂

On my Pro1, all keys are intact but all of them are shiny. When I was holding a less-used Pro1 in my hands, I was wondering it was originally matte - it looked a bit strange for me at first. 😄

it was issues getting them off, might be a bigger issue putting them back though 😁 I i belive the keys on a gamer keyboard is pushed a little bit more frequent than the keys on my phone 🙂

Paint on gamer RGB keycaps doesn't last long and these will be hit by fingernails more often so chipping will surely be even worse. Maybe you could doubleshot with a burnably thin layer of black over transparent? Or depending how the keys work maybe you could paint and laser the legends on the back? I was considering chopping up my keyboard to create something as close to the ISO-Colemak layout I've been using in Sailfish for years but your idea is better 🤣

I'm planning to cast key caps in transparent acrylic or epoxy resin, paint them black on the top and then laser etch the new characters on them.