dumb question asked too late for Pro 1x

[hling 7]

What does everyone do with protecting their Pro 1x?  My immediate question is actually, " how does one get their camera lens cover replaced..." because stupidly I dropped my phone twice in a day, and did not realize until the next day that the camera lens had cracked and a piece is actually gone (after I tried to tape over it, the tape lifted it off).  So, as I felt really stupid for dropping the phone, I thought that if I HAD a protective case It might have been less damages done, but that I didn't have a case because it's a tricky phone for a case unless i had the skill to make one myself.

Tips on either one of the questions would be much appreciated.

[CornholioGSM 354]

...glass over camera is just glued with good double side tape.

If you want i can maybe sent you camera glass - but from Pro1 (notX) - so for double camera....but it is not problem i mean.

...if you want it then write me please tomorrow PM.

 

BTW for protect camera glass buy tempered protection glass from ali - search for redmi note 7

[Lollerobot 10]

I've 3d printed the hard case and glued it to a somewhat correct size leather case.

There was a topic here somewhere that has a list of leather cases that fit the Pro1x dimension wise, though none just fit without tinkering with the case a bit.

[hling 7]

On 4/22/2025 at 5:06 PM, CornholioGSM said:

...glass over camera is just glued with good double side tape.

If you want i can maybe sent you camera glass - but from Pro1 (notX) - so for double camera....but it is not problem i mean.

...if you want it then write me please tomorrow PM.

 

BTW for protect camera glass buy tempered protection glass from ali - search for redmi note 7

Thank you for your reply and the kind offer!  I ordered the Redmi Note 7 camera glass just now.  I was guessing on the glass , perhaps Samsung A10? But now I will get the Redmi note 7 glass.

[hling 7]

15 hours ago, Lollerobot said:

I've 3d printed the hard case and glued it to a somewhat correct size leather case.

There was a topic here somewhere that has a list of leather cases that fit the Pro1x dimension wise, though none just fit without tinkering with the case a bit.

I was looking online, and guesstimating.  There was a Moxee M2160 that looked similar, except for the charging connector being on the back of the case instead of at the bottom of the case.  I might try to get a wallet case for that phone and see how close i get.

Thank you for your reply!