Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 01/11/2022 in Posts

  1. Right - for example, if electrical design of Pro1-X seems to be done (which is the case hopefully), they can move to an other product without affecting Pro1's future development. If Pro1-X is mechanically complete, engineers may design something else mechanically. That way a company may keep its employees and make profit with something else when development of a product has been finished. Also that would mean a development of a future phone would be easier if you could keep your employees... Basically development of Pro1-X should has been already finished and manufacturing it the
    3 points
  2. Definitely! But with only one product that had to be delayed again and again for mostly no reasons of your own, with what would you pay your debts? Using the delay to design and market something else, potentially with a good profit margin, too, thereby hoping to keep your company afloat, actually might be the best option for enabling you to finally pay those debts.
    2 points
  3. Yes, just tested that: USB mouse works for pattern-based unlocking, even if one connects the mouse only while the phone is already locked. Bluetooth mouse could work, if it is already paired with the device and BT is switched on. Otherwise probably not ...
    2 points
  4. Right, that was what I have tried to point at. So an electrical engineer can do schematics and PCB design and microcontroller programming (but not every electrical engineers do all of them and the same level) and a mechanical engineer may do assembly-related designs (including the whole body) and modifications and usually high level software is also related to another team. It is not necessarily work this way but these are different professions and one territory may need specialists like designing multi-layer, high frequency PCB needs a special knowledge and correct antenna design ne
    1 point
  5. I think if you may connect a wired mouse to the phone using an OTG conversion then you can give input pattern using a mouse pointer.
    1 point
  6. Cannot say whether it's discharging as quickly as it would be without being connected, but yes, my impression is that in both cases (both the "not charging" state and, like this time, "discharging"), the phone is actually discharging. I'll have a closer look, though, as I'm also running the AccuBattery app which should be able to authoritatively answer that question. [Edit:] Yesterday: 06:52: used for 32m, 75% -> 70% (this was the normal discharge cycle. After that, charging should have started again) 07:24: used for 7h 38m, 71% -> 28% (connected all the time; at 28%, st
    0 points
  7. Spoken too soon; in the morning (now on 18.1-20211115-NIGHTLY-pro1), while connected, the battery was down to 20%, there was no flash symbol in the status bar and AccA again reported "not charging". (It's been some time, but I think the latter should have read "there was a flash symbol"...) Strange things continue to happen. Today, just before successfully updating to 18.1-20220110-NIGHTLY-pro1, the phone was down to 28%, "discharging", no flash symbol, while being connected to a charger. No connection problem, I immediately tried different cables and chargers. After reboot, cha
    0 points
  8. it is better to pay your debts first before doing new things
    0 points
×
×
  • Create New...

Important Information

Terms