Leaderboard

@dreamflasher That, printed on a slip of paper in bold red type, should be (have been) packaged with every new device... 😉

Lineage-20.0-20230824-nightly-pro1x with Aug 5th security patch installed smoothly via ADB sideload. Indeed I got the PTMBAN* reported in the Pro 1 Lineage 20 thread. I also flashed via adb sideload the newer MindTheGapps set dated 20230808, plus I reflashed Magisk, That last step may have been unnecessary, but it also didn't hurt, but I didn't have to reopen the Magisk Manager app and just had root as soon as I booted. * The Prompt That Must Be Answered No. This was reported by @EskeRahn in the Pro 1 Lineage 20 thread. When you adb sideload Lineage now, it reminds you need to reboot i

I believe Fxtec will do it if you contact them. You'd be without the phone for a while though. My guess is a repair shop could do it if given that link to the instructions on how it is done. They are generally used to taking apart many different models of phones.

I should mention that I find it short sighted that the phone makers require the phones to boot (even to just the battery charging screen) in order to charge the battery. They should have these set up so that the charging can take place with the phone completely off. There might be some sort of limitation where it can't fast charge until the cpu is involved, but it should do a low level charge, at a bare minimum, until the battery gets to a state where it can boot to the charging screen. That type of failsafe seems a lot better than shutting down when they think it is getting into the danger

I was pondering that too. I don't know if it would matter. If someone has a phone plugged in, I am guessing it takes about the same power to get booted enough to start charging when booting fully as it does to get to the charge only boot screen. But I could be wrong. I have it turned on with my phone, because the phone can charge a lot faster with it powered off. I use that if I am in a hurry sometimes and want to get enough charge in the phone. Doesn't seem to get as hot on fast charging when powered off.

One thing that people may way to consider to avoid this issue is installing an app that shuts down the phone before it gets to the critical level. This won't help people who have this happen before installing the app or have the battery run out when the phone is off for a long period of time and the battery drains, but it can help those of us who are able to do this step before it happens. I believe this requires root (my Pro1X is rooted). The app I installed is called Advanced Charging Controller App (ACCA). It isn't on the play store. Here is its page: https://f-droid.org/en/packag

Hi guys I had me pro1 in the drawer box for i while now since it won't boot. Tried today to EDL flash it, everything seems good, device is detected as it should, flashing progress is going as it should. When flashing is done, i see the message that I can remove the device. But, it only boots in to fastboot, don't boot normally and won't boot to recovery. Any ideas?