Jump to content

Recommended Posts

On 5/12/2020 at 11:42 AM, EskeRahn said:

Just got the above in the mail today, and it is a good fit in both portrait and landscape AND has the benefit mounted in a car to fit almost any phablet with a short edge between 64 and 88mm.

To use while charging in portrait, I will suggest to make a small cut in one of the feet.2038628361_IMG_20200512_10232601.thumb.jpg.52643c57c1f8c2ac2088e099fbc26e07.jpg

(Note that in portrait the 'toes' does not catch the edge of the display-part of a Pro1, but it still can not fall out)

delivered this holder today....but was really needed some modding because fx is too thick



  • Like 1
Link to post
Share on other sites
  • 2 weeks later...
  • Replies 77
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Popular Posts

And adapt quite well  

3D Files are here : https://www.thingiverse.com/thing:4236222 (thingiverse is quite slow today)

I used Fusion360: Printed on a Prusa I3 mk3:  

Posted Images

On 12/31/2019 at 2:38 PM, mosen said:

Since Pro¹ is 73,6mm wide i can safely say i got the 62-77mm variant.
Most likely mine is an old model of 511307. But since 711042 starts at min 70mm it should also fit, right.

Now that I finally got a phone, I can confirm that the Brodit 711042 doesn't quite accommodate the thickness of the device (and just holding the keyboard part with it doesn't really work, either), so I got a 511307 and it's good indeed!


Edited by Rob. S.
  • Like 2
  • Thanks 1
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information