Leaderboard

Did a factory reset, flashed the original images, flashed LOS recovery, the LOS installation instructions state to wipe data/factory reset before flashing LOS, which I did – but that's apparently a big error in the guide (https://wiki.lineageos.org/devices/pro1/install). That apparently removed the adb connection, so I couldn't flash LOS anymore. Tried to reboot, but now the phone doesn't boot anymore. Stuck at the logo forever. Also no possibility to ADB or fastboot connect 😕 How can I debrick? Retried adb sideload and restart to recovery a dozend times and suddenly it worked.

Depending on your mobile provider, the Pro1x is 4G, VoLTE & VoWiFi compatible. I took a call VoWiFi at work today. But I have mobile service restricted to 3G - otherwise cell connectivity is horrendously unreliable 😪

In principle, it does support 4G, but it doesn't work everywhere.

I suspect that you kept missing the right sequencing, until you finally hit it in trying everything. The steps and order of those steps are important. The 25 cent version: After you fastboot flash boot.img and dtbo.img you then reboot into recovery. Next you factory reset to make sure userdata has been wiped. You then go into the advanced menu and enable adb. Then you go to applu update and apply for adb and issue the adb sideload command from your computer. When it has completely installed, reboot to recovery. You may then sideload Gapps or anything else. You MUST do this final r

What I've done is program MacroDroid with the 'Shake' trigger and an IF/ELSE clause. Now a slightly positive shake toggles the screen either On or Off, depending on it's current status. I had it waking based on the Prox.sensor previously but this needed two macros, & was definitely battery hungry. I'm hoping the 'Shake' trigger will be less of a power drain; I defo find it easier & more intuitive to use.