Leaderboard

This one? https://drive.google.com/file/d/1ITmEdNWeGZTAmkmMTW07qvmHn8u9oyNl

See my edited post - ACC is working really well including charge current and voltage limits. One time only I encountered the "not charging" state, and this corresponded with when my battery nearly self-destructed. Not sure if this was coincidence or if it sensed too high battery temp or what. The charge control on the Pro1 is more advanced than on previous Qualcomm MSM chipsets I've worked with. For one thing, it has the "Max USB current" setting (see in my screenshot further up in thread) and this gets set based on a number of parameters. It is this parameter which gets set by ACC t

I've seen a couple of references on the forum to an official Fxtec Pro 1 Service Manual v1.0, but the links seem to be dead. Has anyone got a working link for this, or able to upload it maybe as an attachment in the forum, or somewhere permanent like archive.org?

pro1disassembly.pdf

Yes, it is. Where ACC also does not help is the mysterious issue of phones suddenly stopping to charge (with the status bar still showing the arrow) which some of us have been experiencing for some months now every once in a while. AccA then reports the state being "not charging" instead of either "charging" or "discharging", and the only remedy so far is to reboot the phone. (There was already a lot of discussion about this here, and If I remember correctly, the same or at least a very similar issue has been noticed on other phones, too, with fixes being rolled out for their specific bui

Thanks for advice @Rob. S., ACC seems to work really well for what it does. When I tried "test battery idle mode" it just hung saying "this will take a few seconds." After waiting a minute or two I gave up. Is this the same experience you have? Just tested charge rate and voltage limits and both work perfectly. This is with latest stable LineageOS 11. So I don't even need to dig into PMIC settings. ACC is doing everything. Will see how it goes - at one point the ACC daemon died. But as of right now it is working! Which ROM were you testing on when this did not work?

Battery idle mode would be awesome. E.g. in the car, which is already a bad high-temp environment, this would mean you could run the phone with high-current power supply to run navigation apps etc., without touching the battery. I don't think I've ever seen that in a phone. Does ACC have that feature on some devices?

...."deglue" display from frame is simple. I have preheater for it , sometime i am too lazy to go to second room where is preheater 🙂Solution is simple - buy zippo lighter fuel, littlebit moisten gap between lcd glass/frame...and then use carefully razor blade and put it between glass and frame - but not cutting! ...thats all. Edit - razor blade is needed because is thin!!!