Topics

Hello,  Soo today i have tested today touch fix on new display from ali. Method with goodix app does not work on los22...all was fine...selinux set, read data from display was working too, but after flashing new firmware phone makes reboot and nothing - still same.   But method - flashing stock rom without wipe, wait for boot and then flash back los22 works fine 🙂 ...only reinstal magisk was needed

I used my Pro 1 with VoLTE off during the past 3 days.  At nights I set it to "Airplane Mode" on and Wifi on. For this, VoLTE off made no difference regarding the battery drainage. But during the day - with  "Airplane Mode" off and "normal" phone usage, VoLTE off reduced the battery drainage. It is still not as good as with Lineage 22.1, but my Pro 1 survived the days without additional charging in the afternoon. The past two days were weekend days, where my phone usage is different to week days. Therefore I have to observe this a few more days. I also received a new 5G SIM card from my provider (I did not order this - they are changing their system - it is a pity, that the Pro 1 does not use 5G). I put the new SIM card in the phone today, because I have to use it before the end of the month. And I switched VoLTE on. I will check for two or three days and then report here, if the new SIM card has an effect on the battery drainage.  After that test I will continue with the VoLTE test.   

Which error did you get directly from the laptop. Timeout? I'm going to try with a dock or a hub tomorrow.

Hi all, Does anybody have a copy of the qfpkg_cli tool? @tdm's file repository is gone. After receiving and reviving my DOA Pro¹X via EDL using the linux "qdl" tool, I'd like to give my long dead Pro¹ a shot. I can make it boot into EDL mode but @tdm's graphical qfpkg_gui tool on Linux just reports a timeout immediately after clicking the "Flash" button. Unfortunately the power switch on this Pro¹ is shot after I replaced the screen on it for the second (or 3rd? don't remember) time. So it's kinda difficult to restart the phone to start the EDL sequence from the beginning every time. So, before I pull this phone apart again and try wiring an external power SW to reproduce the EDL boot sequence more reliably, I'd like to give the cli tool a try and especially check for any debug messages that might give me greater insight on what's wrong. Thanks!

I will test it tonight with VoLTE off.